User's Guide

56
Static QoS-Download Rate / Static QoS-Upload Rate sections are configurable when the Limit Rate
is enabled. These sections allow the user to set Download / Upload rates for specific IP
address(es). Click the ADD button and enter each hostname, IP address, MAC (optional) and Limit
Rates in bytes/sec, Kbytes/sec, or Mbytes/sec. These Static QoS Rates are configurable in either
Limit Type: Static or Limit Type: Dynamic (described in the Limit Rate settings above).
Figure 63: Services > QoS over Nftables > Traffic Priority
Traffic Priority Settings section lets the user configure traffic priority by protocol and service.
Click the ADD button and select a protocol (TCP, UDP, UDP-Lite, SCTP, or DCCP), priority (1 is
highest), service (telnet, http, https, or a port number – multiple entries are possible, separated
by a comma), and an optional comment. For multiple protocols, click the ADD button and repeat
as needed. Click Save & Apply.
NOTE: When Limit Enable and/or Enable Traffic Priority are disabled, the
corresponding Static Rates and/or Traffic Priority settings are not displayed until after
clicking Save & Apply. Likewise, if Limit Enable and/or Enable Traffic Priority are enabled,
their corresponding settings will not appear in the display until after clicking Save & Apply.
If either option is disabled and later re-enabled, any settings the user has previously
configured will be available as previously configured.