User Guide

Bria iPhone Edition User Guide
47
Verify TLS Cert Applies only if you use TLS as the transport.
• On (default): Bria attempts to verify the certificate, sent by the SIP server, to see if it is
trusted. For the certificate to be trusted, a corresponding CA certificate, provided by
your VoIP provider, must be installed on your device (using the iPhone Configuration
Utility for example).
• Off: Bria accepts the certificate without attempting to verify it.
Alert In Background • On: Bria sends notifications when an account fails to register. Bria also notifies the
user after the account is successfully re-registered. Make sure that Bria notifications
are enabled under iOS Settings.
• Off (default): Bria does not send notifications regarding account registration errors.
Support RPort • On: the outgoing INVITE message will have an RPort parameter inside the Via
header, which indicates that Bria supports RFC 3581. If the server also supports RFC
3581, the server should respond with the RPort parameter set to the incoming public
IP port and the received parameter set to the public IP address. This is the default
behavior in previous Bria versions.
• Off: Bria does not have the RPort parameter in the Via header.
Support PRACK • On: Bria advertises that it supports “100rel” and allows PRACK, as defined in RFC
3262. The outgoing INVITE message will have “100rel” in the Supported header and
“PRACK” in the Allow header. This is the default behavior in previous Bria versions.
• Off: Bria will not advertise these features; there will be no “100rel” in the Supported
header.
Verbose Logging Leave this setting OFF unless customer support instructs you to turn it ON in order to
troubleshoot a problem you are having on your device. See page 53.
Send Log Tap to upload the current log to customer support. See page 53.
Call Statistics To show detailed information about the current/last call. For example, the number of
packets lost.
For an ongoing call, the statistics information refreshes every second. Tapping the
Refresh button stops auto refresh and presents you with a snapshot of the most current
statistics. To enable auto refresh again, either long-tap the Refresh button, or leave the
statistics page and come back again.
Field Description