Road-towable Safety & Operating Instructions

CALL TOLL FREE 1-800-DR-OWNER 29
Reassemble
Bottom Discharge model:
1. Hold the Deflector (Figure 10 on page 28) in place at the Discharge opening of the Chipper.
2. Place a 5/16" Flat Washer on a 5/16"-18 x 4" Bolt and then slide the Bolt through both the top two
(2) holes of the Chipper body and the Deflector.
NOTE: Be certain that the Bolt attaching the Deflector to the Chipper passes through the pipe (tube)
welded to the Scroll (Figure 10 on page 28).
3. Add a 5/16" Flat Washer to the end of the Bolt followed by a 5/16"-18 Lock Nut. Do not tighten at
this time.
4. Repeat Steps 2 and 3 for the lower Deflector attachment Bolt.
5. Pull up on the end of the Deflector and tighten the two (2) Lock Nuts.
6. Reconnect the battery negative terminal cable, the spark plug wires and start the Chipper engine;
allowing the material in the Chipping Chamber to discharge.
7. If the Chipping Chamber does not clear and the flywheel is still jammed, repeat above process.
8. Be certain the Chipping Chamber is clear before trying to process more material into the Chipper
Hopper.
Top Discharge model:
1. Follow the installation instructions on page 17.
2. Reconnect the battery negative terminal cable, the spark plug wires and start the Chipper engine;
allowing the material in the Chipping Chamber to discharge.
3. If the Chipping Chamber doesn’t clear and the flywheel is still jammed, repeat above process.
4. Be certain the Chipping Chamber is clear before trying to process more material into the Chipper
Hopper.