Road-towable Safety & Operating Instructions

32 DR

18 and 19 HP ROAD-TOWABLE CHIPPER

Grease Fittings

Your DR ROAD-TOWABLE CHIPPER was greased at the Factory. The operator needs to lubricate the

Chipper Side and Drive Side Bearings periodically.

BEFORE PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION, STOP THE ENGINE, WAIT FIVE

(5) MINUTES TO ALLOW ALL MOVING PARTS TO COME TO A COMPLETE STOP AND COOL. DISCONNECT

THE SPARK PLUG WIRES, KEEPING THEM AWAY FROM THE SPARK PLUGS.

Supplies Needed:

• Flexible hose grease gun

• Lithium grease

• Clean cloth

• 5/32" Allen Wrench

• Loctite

243 (if needed)

1. Wipe all dirt, etc., from the grease fittings with a clean cloth (Figure 11).

2. Apply no more than three (3) pumps of quality general-purpose lithium grease with a hand-

pumped grease gun to each grease fitting, one (1) on the Chipper Side Bearing and one (1) on the

Drive Side Bearing.

OVER LUBRICATION CAN ALSO DAMAGE THE BEARINGS.

3. After greasing, check the Side Bearing Collar Set Screws for tightness with a 5/32" Allen Wrench. If they

are loose, reset them with Loctite

243, obtainable at any hardware store.

Figure 11

Side Bearing

Grease Fitting

Side Bearing

Collar Set Screw

(

laces

)