Operating instructions

DR
ALL-TERRAIN
FIELD and BRUSH MOWER Safety & Operating Instructions 21
Chapter 5: Maintaining the DR ALL-TERRAIN
FIELD
and BRUSH MOWER
This chapter covers regular maintenance procedures that will ensure the best performance
and long life of your machine. For engine maintenance, please refer to the engine owner’s
manual that came with your mower. Service intervals listed in the checklist below supercede
those listed in the engine owner’s manual.
Regular Maintenance Check List
Note: Service intervals shown are considered maximum under normal operating
conditions. Increase frequencies under extremely dirty or dusty conditions.
Procedure
Before Each
Use
Every 25
Hours
Every 100
Hours
Check Operator Presence Switch
Check Engine Oil Level
Check General Equipment Condition
Check Blade for Sharpness
Lubricate Grease Fittings
Lubricate Clutch & Brake Cables
Lubricate Chain
Check Tire Pressure
Clean Air Filter & Precleaner*
Change Engine Oil & Filter* 1
st
time 5 hours
Check Parking Brake Adjustment
Clean Engine Exterior & Cooling Fins
Check All Belt Tensions & Condition
Check cable connections
Replace Spark Plug(s)
Replace Air Filter & Precleaner
* The engine on your DR may not have a precleaner or oil filter.
WARNING! Some of the following procedures require access to the
underside of the machine. If you need to tip the machine back or on its side
(with the discharge chute facing up), you must first disconnect the spark plug
w
ire
(
s
)
, drain the oil and
g
as, and remove the air filters.