Tus neeg siv phau ntawv
Table Of Contents
- POC-621 Series (DC-/ AC-in model)
- Contents
- 1 General Information
- 1.1 Introduction
- 1.2 Specifications
- 1.3 Dimensions
- Figure 1.1 Dimensions of the POC-621
- Figure 1.2 POC-621 Hot Swappable Battery Pack Dimensions
- Figure 1.3 POC-621 with Smart Card Reader Dimensions
- Figure 1.4 POC-621 with RFID & Camera Accessory Dimensions
- Figure 1.5 POC-621 VESA Mounting
- Figure 1.6 POC-621 Series Front Panel
- 1.3.1 Optional Modules
- 1.3.2 Cleaning and Disinfecting the Solution
- 1.4 Operating Principle
- 1.5 Intended User Profile
- 1.6 Front Bezel Button
- 2 System Setup
- 3 Hot Swapping Battery Pack Operation
- 4 Operation and Safety
- A POC-621 Series VESA Mounting
- B Driver Installation
- C PCM-8722 Connector Map
- D PCM-8722 Jumper Settings
- D.1 PCM-8722 Jumper setting
- Table D.1: CN3 ME Manufacturing Mode
- Table D.2: CN5 Clear CMOS
- Table D.3: CN6 (Not Install) Clear ME
- Table D.4: CN8 (Not Install) System Reset
- Table D.5: CN13 LVDS Voltage Setup
- Table D.6: CN40 Power Button (Internal Test Only)
- Table D.7: PCN4 Power Debug (Reserved)
- Table D.8: SW1 Board Setup
- Table D.9: SW1 Pin 4 Speaker Function
- Table D.10: SW2 Panel Resolution/Type Setup
- D.1 PCM-8722 Jumper setting
- E Advanced BIOS Functions
7 POC-621 Series User Manual
Chapter 1 General Information
Figure 1.5 POC-621 VESA Mounting
VESA Mounting: 75 x 75 mm; 100 x 100 mm;
3.93 x 3.93 in, 2.9 x 2.9 in
Mounting screws: M4, 0.7pitch, 10mm long
Figure 1.6 POC-621 Series Front Panel
(1) Power
(2) Volume Up/Down
(3) Touchscreen Status Control
(4) Read Light Control
(5) Brightness Decrease/Increase
(6) RFID or Smart Card Reader (Optional)*
RFID or Smart Card Reader - choose 1
Warning! Use suitable mounting apparatus to avoid risk of injury. This solution
should be mounted by trained and authorized personnel with adequate
allowances for quality of materials used to make the connection
Avertissement! Utilisez un appareil de montage approprié pour éviter tout risque
de blessure, il doit être monté par un personnel formé et autorisé
sur des tolérances adéquates pour la qualité des matériaux util-
isés pour effectuer la connexion