Tus neeg siv phau ntawv
Table Of Contents
- POC-621 Series (DC-/ AC-in model)
- Contents
- 1 General Information
- 1.1 Introduction
- 1.2 Specifications
- 1.3 Dimensions
- Figure 1.1 Dimensions of the POC-621
- Figure 1.2 POC-621 Hot Swappable Battery Pack Dimensions
- Figure 1.3 POC-621 with Smart Card Reader Dimensions
- Figure 1.4 POC-621 with RFID & Camera Accessory Dimensions
- Figure 1.5 POC-621 VESA Mounting
- Figure 1.6 POC-621 Series Front Panel
- 1.3.1 Optional Modules
- 1.3.2 Cleaning and Disinfecting the Solution
- 1.4 Operating Principle
- 1.5 Intended User Profile
- 1.6 Front Bezel Button
- 2 System Setup
- 3 Hot Swapping Battery Pack Operation
- 4 Operation and Safety
- A POC-621 Series VESA Mounting
- B Driver Installation
- C PCM-8722 Connector Map
- D PCM-8722 Jumper Settings
- D.1 PCM-8722 Jumper setting
- Table D.1: CN3 ME Manufacturing Mode
- Table D.2: CN5 Clear CMOS
- Table D.3: CN6 (Not Install) Clear ME
- Table D.4: CN8 (Not Install) System Reset
- Table D.5: CN13 LVDS Voltage Setup
- Table D.6: CN40 Power Button (Internal Test Only)
- Table D.7: PCN4 Power Debug (Reserved)
- Table D.8: SW1 Board Setup
- Table D.9: SW1 Pin 4 Speaker Function
- Table D.10: SW2 Panel Resolution/Type Setup
- D.1 PCM-8722 Jumper setting
- E Advanced BIOS Functions
POC-621 Series User Manual 8
1.3.1 Optional Modules
Memory: Up to 32GB DDR4 SODIMM x 2
Primary Storage: NVME (M2 2280, PCIe Interface)
2.5" SATA SSD
Wi-Fi and Bluetooth module: Intel Wireless-AC9260, Intel Dual Band Wireless-
AC 8265
RFID module: RFIDEAS OEM-7522AXU
Smart Card
Li-ion Battery 8400mAh 10.8V 190.72Wh 3S3P
Backup battery: Optional (choose either 1 x battery or PCIe x4)
Hot swappable battery pack: Optional with 2 x batteries (choose either backup
battery or hot swapping battery module)
Camera: 5MP Auto Focus
Touchscreen: Optional AR/AG process
Some of the above optional modules are mutually exclusive to each other. Contact
Advantech for further details.
1.3.2
Cleaning and Disinfecting the Solution
The POC may become dirty during and should be cleaned regularly.
Steps:
1. Prepare cleaning water.
2. Wipe the POC with a clean cloth that has been moistened in the cleaning solu-
tion.
3. Wipe thoroughly with a clean cloth.
Caution!
Do not immerse or rinse the POC or its peripherals. If you acciden-
tally spill liquid on the device, disconnect the unit from the power
source. Contact your IT support department regarding the contin-
ued safety of the unit before placing it back in operation
Do not spray cleaning agent on the chassis.
Do not use disinfectants that contain phenol.
Do not autoclave or clean the POC or its peripherals with strong
aromatic, chlorinated, ketone, either, or ether solvents, sharp tools
or abrasives. Never immerse electrical connectors in water or other
liquids.