Tus neeg siv phau ntawv
Table Of Contents
- POC-621 Series (DC-/ AC-in model)
- Contents
- 1 General Information
- 1.1 Introduction
- 1.2 Specifications
- 1.3 Dimensions
- Figure 1.1 Dimensions of the POC-621
- Figure 1.2 POC-621 Hot Swappable Battery Pack Dimensions
- Figure 1.3 POC-621 with Smart Card Reader Dimensions
- Figure 1.4 POC-621 with RFID & Camera Accessory Dimensions
- Figure 1.5 POC-621 VESA Mounting
- Figure 1.6 POC-621 Series Front Panel
- 1.3.1 Optional Modules
- 1.3.2 Cleaning and Disinfecting the Solution
- 1.4 Operating Principle
- 1.5 Intended User Profile
- 1.6 Front Bezel Button
- 2 System Setup
- 3 Hot Swapping Battery Pack Operation
- 4 Operation and Safety
- A POC-621 Series VESA Mounting
- B Driver Installation
- C PCM-8722 Connector Map
- D PCM-8722 Jumper Settings
- D.1 PCM-8722 Jumper setting
- Table D.1: CN3 ME Manufacturing Mode
- Table D.2: CN5 Clear CMOS
- Table D.3: CN6 (Not Install) Clear ME
- Table D.4: CN8 (Not Install) System Reset
- Table D.5: CN13 LVDS Voltage Setup
- Table D.6: CN40 Power Button (Internal Test Only)
- Table D.7: PCN4 Power Debug (Reserved)
- Table D.8: SW1 Board Setup
- Table D.9: SW1 Pin 4 Speaker Function
- Table D.10: SW2 Panel Resolution/Type Setup
- D.1 PCM-8722 Jumper setting
- E Advanced BIOS Functions
POC-621 Series User Manual 20
2.6 Troubleshooting
The following details events in which the system behaves abnormally
In such cases, please refer to the troubleshooting instructions below.
2.6.1 POC not Power ON.
Press the power button but no power on (Power ON Green indicator is still off)
Please check
1. Check that adapter/DCIN is plugged in properly.
2. Check that the adapter/DCIN is plugged in to the correct direction to POC DCIN
Connector
3. Check that the AC power cord plug and adapter are correct
4. Check that the AC power cord is plugged into the wall inlet properly.
5. If there is no adapter plugged in (battery powered mode), please check that the
battery is installed properly and then check the battery’s capacity.
Please unplug the battery pack and press the capacity indicator button on the
battery pack.
The illuminated LED represents the battery capacity.
2.6.2
Adapter Power LED off
The adapter indicator’s green LED remains off.
1. Check that the AC power cord is plugged into the adapter properly
2. Check that the AC power cord is plugged into the wall inlet properly.