Tus neeg siv phau ntawv
Table Of Contents
- POC-621 Series (DC-/ AC-in model)
- Contents
- 1 General Information
- 1.1 Introduction
- 1.2 Specifications
- 1.3 Dimensions
- Figure 1.1 Dimensions of the POC-621
- Figure 1.2 POC-621 Hot Swappable Battery Pack Dimensions
- Figure 1.3 POC-621 with Smart Card Reader Dimensions
- Figure 1.4 POC-621 with RFID & Camera Accessory Dimensions
- Figure 1.5 POC-621 VESA Mounting
- Figure 1.6 POC-621 Series Front Panel
- 1.3.1 Optional Modules
- 1.3.2 Cleaning and Disinfecting the Solution
- 1.4 Operating Principle
- 1.5 Intended User Profile
- 1.6 Front Bezel Button
- 2 System Setup
- 3 Hot Swapping Battery Pack Operation
- 4 Operation and Safety
- A POC-621 Series VESA Mounting
- B Driver Installation
- C PCM-8722 Connector Map
- D PCM-8722 Jumper Settings
- D.1 PCM-8722 Jumper setting
- Table D.1: CN3 ME Manufacturing Mode
- Table D.2: CN5 Clear CMOS
- Table D.3: CN6 (Not Install) Clear ME
- Table D.4: CN8 (Not Install) System Reset
- Table D.5: CN13 LVDS Voltage Setup
- Table D.6: CN40 Power Button (Internal Test Only)
- Table D.7: PCN4 Power Debug (Reserved)
- Table D.8: SW1 Board Setup
- Table D.9: SW1 Pin 4 Speaker Function
- Table D.10: SW2 Panel Resolution/Type Setup
- D.1 PCM-8722 Jumper setting
- E Advanced BIOS Functions
45 POC-621 Series User Manual
Chapter 4 Operation and Safety
4.9 Battery Disposal
When the battery pack has reached the end of its service life, do not use general
household waste for disposal. Follow local laws and government regulations for cor-
rect battery disposal.
Caution! Cover terminals with tape to prevent inadvertent contact with other bat-
teries or metal objects.
Warning! 1. To reduce the risk of fire or burns, do not disassemble, crush, punc-
ture, expose to fire or water, or short the battery’s external con-
tacts.
2. Used batteries may still have a partial charge. If partially charged
batteries come into contact with other batteries or metal objects,
the remaining stored energy may be discharged and cause a fire or
explosion.
ATTENTION! Couvrez les bornes avec du ruban adhésif pour éviter tout contact
accidentel avec d'autres batteries ou des objets métalliques. Cou-
vrez les bornes avec du ruban adhésif pour éviter tout contact acci-
dentel avec d'autres batteries ou des objets métalliques.
AVERTISSEMENT! 1. Pour réduire le risque d’incendie ou de brûlure, ne démon-
tez pas, n’écrasez pas, ne percez pas, n’exposez pas au
feu ou à l’eau, et ne court-circuitez pas les contacts
externes de la batterie.
2. Les batteries usagées peuvent encore avoir une charge
partielle. Si des batteries partiellement chargées entrent
en contact avec d'autres batteries ou des objets métal-
liques, l'énergie stockée restante peut être déchargée et
provoquer un incendie ou une explosion.