Tus neeg siv phau ntawv
Table Of Contents
- POC-621 Series (DC-/ AC-in model)
- Contents
- 1 General Information
- 1.1 Introduction
- 1.2 Specifications
- 1.3 Dimensions
- Figure 1.1 Dimensions of the POC-621
- Figure 1.2 POC-621 Hot Swappable Battery Pack Dimensions
- Figure 1.3 POC-621 with Smart Card Reader Dimensions
- Figure 1.4 POC-621 with RFID & Camera Accessory Dimensions
- Figure 1.5 POC-621 VESA Mounting
- Figure 1.6 POC-621 Series Front Panel
- 1.3.1 Optional Modules
- 1.3.2 Cleaning and Disinfecting the Solution
- 1.4 Operating Principle
- 1.5 Intended User Profile
- 1.6 Front Bezel Button
- 2 System Setup
- 3 Hot Swapping Battery Pack Operation
- 4 Operation and Safety
- A POC-621 Series VESA Mounting
- B Driver Installation
- C PCM-8722 Connector Map
- D PCM-8722 Jumper Settings
- D.1 PCM-8722 Jumper setting
- Table D.1: CN3 ME Manufacturing Mode
- Table D.2: CN5 Clear CMOS
- Table D.3: CN6 (Not Install) Clear ME
- Table D.4: CN8 (Not Install) System Reset
- Table D.5: CN13 LVDS Voltage Setup
- Table D.6: CN40 Power Button (Internal Test Only)
- Table D.7: PCN4 Power Debug (Reserved)
- Table D.8: SW1 Board Setup
- Table D.9: SW1 Pin 4 Speaker Function
- Table D.10: SW2 Panel Resolution/Type Setup
- D.1 PCM-8722 Jumper setting
- E Advanced BIOS Functions
POC-621 Series User Manual 58
Table D.5: CN13 LVDS Voltage Setup
Description Select panel LVDS voltage setting
Setting Function
(1-2) Panel LVDS voltage 5V (Default)
(2-3) Panel LVDS voltage 3.3V
Table D.6: CN40 Power Button (Internal Test Only)
Description Power Button Signal
Setting Function
(Pin 2) Short pin 1 to Power ON system
(No Connect) Normal Operation (Default)
Table D.7: PCN4 Power Debug (Reserved)
Description Power Debug, Internal Test Only
Setting Function
(No Connect) Normal Operation (Default)
Table D.8: SW1 Board Setup
Description Select Board setting
Setting Function
(SW1-1/2/3) Select board type
(SW1-4) Force Speaker always ON