Installation Manual

ManualsBrandsCoverking ManualsAutomotiveCoverking Custom Fit Dashboard Cover for Select Chevrolet Silverado Models - Suede (Black)

INSTALLATION & CARE

CUSTOM DASH AND REAR DECK COVER INSTALLATION

BEFORE INSTALLATION:

• Read entire installation instructions before proceeding

• Make sure dashboard is clean and dry

• Remember to give your dashboard time to conform. It will shape and fit perfectly after a few days.

1. Unroll Cover

Allow it to lie flat overnight if possible.

2. Clean Dashboard

Wipe off with a mild deterent to remove

polish or wax from the areas where the

fasteners will be placed.

3. Pre-fit Cover on Dash

Align contours and cuts. Make sure the

defrost vents (nearest windshield) align with

the cutouts.

TIP: On some vehicles, the material must

be pushed forward between the dash and

windshield. Use a wooden ruler or paint

stick if necessary.

7. Custom Dash Cover Notices

AIRBAG

Your dashboard cover has been manufactured to allow for proper deployment of the airbag safety system. As designed, this product will not obstruct

the airbag. You must not place any fasteners on this area, as doing so may obstruct deployment.Coverking assumes no responsibility for improper

installation of dashboard covers, resulting in obstruction of airbag deployment.

FITMENT ISSUES

If your cover seems too big and hangs over the front of the dash, be sure the cover is pushed all the way back between the glass and front of the dash.

The vent cutouts should match the defrost vents. If needed, use a wooden ruler or similar to push the cover back.

4. Apply Fasteners

Remove cover from dash. Cut the fastner strip

into 1-inch pieces and apply where needed. You

may need a few fasteners near the windshield

(on each side), several small pieces at the

front edge and one or more in each contoured

area. To remove fasteners, slowly peel to avoid

damaging vinyl.

5. Pre-shape

Speed up the shaping process by bending or

creasing the cover to help it conform to the

curves of your dash.

6. Apply Dash Cover

Realign the cover with fasteners and set it into

place for the final time.

TIP: Because of auto assembly tolerances or variations in

the position of replacement windshields, dash covers may

require trimming on the windshield edge.

PlASTICIZER MIGRATION

This problem is common for certain car models. The

plastic formulation inside the dashboard begins to break

down, causing a darkened area to appear on the surface.

This flaw may occur on both covered and uncovered

dashboards. Coverking assumes no responsibility for such

occurences.

Apply

Fasteners

Align with

Fasteners

Summary of content (1 pages)

PAGE 1
INSTALLATION & CARE CUSTOM DASH AND REAR DECK COVER INSTALLATION BEFORE INSTALLATION: • Read entire installation instructions before proceeding • Make sure dashboard is clean and dry • Remember to give your dashboard time to conform. It will shape and fit perfectly after a few days. 1. Unroll Cover Allow it to lie flat overnight if possible. 2. Clean Dashboard 3. Pre-fit Cover on Dash Wipe off with a mild deterent to remove polish or wax from the areas where the fasteners will be placed.