Installation Manual

4. Install Console Cover (If Applicable)
Step 1. Slide on console top,
then console bottom.
Step 2. Pass console bottom
flap through opening, then
attach velcro.
Step 3. Place base cover in place, slide
flap (E) through. Attach and tighten
the buckles (A,B) and attach hooks
(C,D).
5. Finishing Touches
Headrest Holes: Before you reinstall your headrests, stretch the
material over the headrest bases. Tuck the material under the
bases for a super clean, tight finish. Reinstall headrest.
Tuck & Adjust: Adjust material around armrests, levers, lumbar support
adjusters, etc. Material should be tucked under/behind.
Tighten After Break-in: After the first 2 weeks of use, tighten the seat back covers by releasing the velcro, pulling the material very tight, then re-
attaching the velcro. Also, tighten the seat bottom cover buckles.
Step 2. Then attach the side hooks (C,D) to the
buckle straps.
3. Install Seat Bottom Cover
A A
C
C
B B
D
D
E
E
A
C
B
D
E
A
C
B
E
Step 1. Position cover over seat bottom. Pass flap
between seat back and seat bottom. (Similar to the
seat back cover installation, it may be easier if you fold
the seat back forward) Join and tighten the buckles
(A,B) under the seat.
View from under the seat