Installation Manual
CUSTOM VEHICLE COVER INSTALLATION
BEFORE INSTALLATION:
• Read entire installation instructions before proceeding
• Make sure vehicle is clean and dry
• Check for any sharp objects on the vehicle that may damage the cover
1. Unroll cover from front to back 2. Unfold outward (first install mirror
pockets over each rear-view
mirror, if applicable)
3. Pull cover over front and rear
bumpers (The elastic will keep the cover in
place under normal conditions)
4. Secure with OPTIONAL Lock & Cable Kit for added security
(Using the built-in grommets- outdoor materials only)
5. Removal
• Fold up both sides of the cover onto the top
of the vehicle into a long strip (2’ wide)
• Start at the rear and roll cover toward the
front
• Store the cover in a storage bag when not
in use
INSTALLATION & CARE
6. Vehicle Cover Care
WASHING/DRYING/REPAIR
• DO NOT machine wash Satin Stretch vehicle covers - hand wash or dry clean only.
• All other vehicle covers should be ONLY washed in a commercial machine, on cold, with mild detergent.
• DO NOT place in a dryer - air dry only
• To wash by hand, Install the cover on your vehicle in a shaded area and hose off any loose dirt. If necessary, wash it further witha soft sponge or
cloth soaked in mild, bio-degradable cleaner. Hose it down again and hang to air dry. To clean the inside, simply install the cover inside-out and
follow the same steps.
• To repair small punctures, seal with Shoo Goo 2 (available at most sporting goods stores)
IMPORTANT WARNINGS:
• Do not cover a recently painted vehicle immediately. Check with your painter or body shop for recommended cure time. Premature use of a cover in
this situation could result in damage to repainted surfaces or lacquer paint. Coverking is not liable for this damage.
• Do not cover a wet vehicle
• Do not cover a vehicle with convertible top down, windows or sunroof open, or T-tops removed
• Do not use a cover while trailering vehicle
• Do not remove the cover in the unusual circumstance that a layer of ice has formed between the cover and the vehicle. Pour warm water over the
cover to expedite thawing, as this ice must be thawed before removal.
• Do not rely solely on the elasticized bottom of the cover in even moderate winds.
• Utilize the integrated security grommets in any substantial wind is expected. If high wind conditions are present (30+mph), remove the cover.
• Coverking’s liability is limited upto the cost of the product’s purchase price.