Product Manual

ManualsBrandsCovidien ManualsDiagnosticsGenius 2 Blackbody Calibration Checker

kENDALL

GENIUS

™

Checker / Calibrator

Operation and Service Manual

Appareil de vériﬁcation/Calibrateur

Manuel d’utilisation et d’entretien

Prüfgerät/Kalibrator

Benutzer- und Service-Handbuch

Sistema di controllo della

calibrazione/calibratore

Manuale operativo e di assistenza

Veriﬁcador de calibración

Manual de operación y servicio

Kalibreringsenhet

Användar- och servicemanual

Validator

Gebruiks- en onderhoudshandleiding

Veriﬁcador/Calibrador

Manual de utilização e assistência

Kalibrointilaite

Käyttö- ja huolto-opas

Kontrol- og kalibreringsapparat

Betjenings- og servicehåndbog

™

GENIUS

F/C˚

Checker / Calibrator

™

GENIUS

™

Ελεγκτής βαθμονόμησης

Εγχειρίδιο λειτουργίας και σέρβις

Ověřovač/Kalibrátor

Uživatelská a servisní příručka

Ellenőrző/kalibráló készülék

Működtetési és karbantartási kézikönyv

Контрольно-измерительное

устройство/Калибратор

Руководство по эксплуатации и

техническому обслуживанию

Kalibrator

Instrukcja obsługi i serwisowania

Kontrolör/Kalibratör

Kullanım ve Servis Kılavuzu

Kontroll- og kalibreringsapparat

Bruker- og servicehåndbok

™ Trademark of Tyco Healthcare Group LP or its affiliates.

RESERVED • 090909 • PRODUCT INFO IN U.S. • 1-800-962-9888 • www.tycohealthcare.com

TYCO HEALTHCARE U.K. LTD GOSPORT, PO13 0AS, U.K.

182563-01

CE MARK SYMBOLS

NON-CE MARK SYMBOLS

ELECTRONIC SYMBOLS AND CERTIFIED TESTING MARKS

Corrugated

Recycles

STERILE

Keep Away

From Sunlight

Keep Dry

Single Use

LOT

0123

FRAGILE

THIS SIDE UP

DEHP – FREE

0°

40°

Avoid Temperature

Extremes

Do not use if package is

opened or damaged.

STERILE R

STERILE

EOSTERILE

STERILE

STERILE R

STERILE

EOSTERILE

Humidity Limitation

Atmospheric pressure limitation

Use By

C US

LATEX – FREE

Caution, consult

accompanying

documents

Consult

Instructions

For Use

MR UNSAFE

NON-PYROGENIC

PROTECT FROM HEAT AND

RADIOACTIVE SOURCES

NON

STERILE

STERILIZE

DO NOT RESTERILIZE

POWDER – FREE

POWDER

CE MARK SYMBOLS

NON-CE MARK SYMBOLS

ELECTRONIC SYMBOLS AND CERTIFIED TESTING MARKS

Corrugated

Recycles

STERILE

Keep Away

From Sunlight

Keep Dry

Single Use

LOT

0123

FRAGILE

THIS SIDE UP

DEHP – FREE

0°

40°

Avoid Temperature

Extremes

Do not use if package is

opened or damaged.

STERILE R

STERILE

EOSTERILE

STERILE

STERILE R

STERILE

EOSTERILE

Humidity Limitation

Atmospheric pressure limitation

Use By

C US

LATEX – FREE

Caution, consult

accompanying

documents

Consult

Instructions

For Use

MR UNSAFE

NON-PYROGENIC

PROTECT FROM HEAT AND

RADIOACTIVE SOURCES

NON

STERILE

STERILIZE

DO NOT RESTERILIZE

POWDER – FREE

POWDER

Status: Approved Doc#: AW10001726 Effective Date: nulldate

10/23/2008 Artwork#s: WN 182563-01 Job#: 16245

Summary of content (14 pages)

PAGE 1
Status: Approved Doc#: AW10001726 Effective Date: nulldate kENDALL GENIUS™ 2 Checker / Calibrator Ελεγκτής βαθμονόμησης Εγχειρίδιο λειτουργίας και σέρβις Ověřovač/Kalibrátor Uživatelská a servisní příručka Ellenőrző/kalibráló készülék Működtetési és karbantartási kézikönyv Контрольно-измерительное устройство/Калибратор Руководство по эксплуатации и техническому обслуживанию Kalibrator Instrukcja obsługi i serwisowania Kontrolör/Kalibratör Kullanım ve Servis Kılavuzu Kontroll- og kalibreringsapparat Bruk
PAGE 2
Status: Approved Doc#: AW10001726 Effective Date: nulldate Table of Contents English Page Section I - Functional Description.................................................................................................................................................... 1 Section II - Precautions and Warnings............................................................................................................................................ 2 Section III - Icon Identification.........
PAGE 3
Status: Approved Doc#: AW10001726 Effective Date: nulldate Section I - Functional Description This manual describes the operation of the GENIUS 2 Checker/Calibrator. This device has been developed to check the accuracy of the GENIUS 2 Tympanic Thermometer and automatically recalibrate the thermometer, if necessary. In addition, the GENIUS 2 Checker/Calibrator has the capability to generate a test report for each thermometer tested and save it to a USB flash drive.
PAGE 4
Status: Approved Doc#: AW10001726 Effective Date: nulldate Section II - Precautions and Warnings • The GENIUS 2 Checker/Calibrator is designed to be operated as specified in this manual. Protection provided by the safety devices in the GENIUS 2 Checker/Calibrator may be impaired if the device is not used in accordance with the directions contained in this manual. • The GENIUS 2 Checker/Calibrator enclosure is not waterproof. Avoid spilling liquid of any kind onto the front panel of the device.
PAGE 5
Status: Approved Doc#: AW10001726 Effective Date: nulldate RK SYMBOLS 23 Section III - Icon Identification SN CE MARK SYMBOLS Single Use RILE R Serial Number Consult Accompanying Documents 0123 STERILE SingleEO Use RILE A STERILE STERILE R STERILE EO Use By Consult Instructions 40° For Use CE Mark LOT Dispose of as Electrical and Electronic Waste 40° 0° High Temperature Target Avoid Temperature Extremes F/C˚ THIS SIDE UP Double or Reinforced Insulation Protection LOT Instructions For U
PAGE 6
Status: Approved Doc#: AW10001726 Effective Date: nulldate Section IV - Required Equipment 1. 2. 3. 4. 5. 6. 7. GENIUS 2 Checker/Calibrator Power module with AC adapter Probe cable Operator’s Manual GENIUS 2 Thermometers to be tested GENIUS 2 disposable probe covers Small Phillips screwdriver Section V - System Setup The following actions should precede use of the GENIUS 2 Checker/Calibrator: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Connect the correct AC plug adapter for your country to the power module.
PAGE 7
Status: Approved Doc#: AW10001726 Effective Date: nulldate Section VI - Operational Procedure The following procedure will describe the steps required to operate the GENIUS 2 Checker/Calibrator. In order to facilitate familiarity with the product, it would be advisable to use this section of the manual during the calibration check of the first few thermometers.
PAGE 8
Status: Approved Doc#: AW10001726 Effective Date: nulldate Set Date and Time The Set Date and Time screen menu option is used to setup the date and time that is used on the test report. The time and date are internally stored and automatically updated when the unit is powered up. To enter time, use the encoder knob to select the hours and minutes. Note: the hours is setup using a 24 hour clock format, where 1PM is entered as 13:00 etc.
PAGE 9
Status: Approved Doc#: AW10001726 Effective Date: nulldate S™ NIU ºC º F GE ˚ F/ C Ch G ec ENI ke US r/ ™ Ca lib rat or F/ C ˚ ™ Figure 3 - Proper Insertion of GENIUS 2 Probe Tip into Target Step 4: The insertion of the probe tip into the target will automatically be detected and the screen display will change to “Press GENIUS 2 Thermometer scan button.” Press the scan button on the GENIUS 2 Thermometer while it is inserted into the Low temperature target.
PAGE 10
Status: Approved Doc#: AW10001726 Effective Date: nulldate Step 8: After the pass/fail Results screen has been displayed, press the encoder knob to display a second Results screen containing the target temperatures, the GENIUS 2 readings, and the target versus thermometer variances. Step 9: The next screen will display “Write report to USB flash drive?” and display Yes and No below. If a report is desired, insert a flash drive into the front panel USB port.
PAGE 11
Status: Approved Doc#: AW10001726 Effective Date: nulldate Error 7: Wrong Target This error is an indication that the GENIUS 2 Thermometer has been inserted into wrong target or was inserted into the target prematurely. Please take care to follow the instructions on the screen and not perform steps prior to the instructions being displayed. The Error screen will be displayed for 60 seconds before returning to the Main Menu. To exit the Error screen sooner, press the encoder knob.
PAGE 12
Status: Approved Doc#: AW10001726 Effective Date: nulldate General Cleaning Instructions Cleaning of the GENIUS 2 Checker/Calibrator may be performed as follows: • FIRST, UNPLUG THE GENIUS 2 Checker/Calibrator FROM POWER SOURCE. NEVER CLEAN THE DEVICE WHILE CONNECTED TO THE MAINS SUPPLY. • A mild detergent should be used for general cleaning of outside surfaces. Also, a cloth damped with isopropyl alcohol can be used to clean the unit. DO NOT USE abrasives or solvents.
PAGE 13
Status: Approved Doc#: AW10001726 Effective Date: nulldate Section XI - Customer Service The GENIUS 2 Checker/Calibrator requires factory calibration and inspection once a year. Notify and return the device to Tyco Healthcare/ Kendall on or before the calibration date for the Checker/Calibrator. The Checker/Calibrator will display a message one month prior to the calibration date as a reminder. CAUTION: THERE ARE NO SERVICEABLE PARTS INSIDE, RETURN TO FACTORY FOR SERVICE.
PAGE 14
Status: Approved Doc#: AW10001726 Effective Date: nulldate Section XIII - Electromagnetic Conformity Declaration The Genius 2 Checker/Calibrator has been built and tested according to IEC/EN61010-1 and EN61326-1 standards The Checker/Calibrator is intended for use in the electromagnetic environment specified below. The user of the equipment should assure that it is used in such an environment.