Operation Manual

iAUDIO G2

1. When you insert iAUDIO installation CD in the CD-ROM drive, the installation program starts

automatically. It may not start automatically depending on the settings of Windows. In this case, run

x:\setup.exe or x:\JetShell\setup.exe. (where x is the letter of your CD-ROM drive)

2. When the installation ﬁ nishes, Start -> Program -> COWON -> iAUDIO G2 program group is

created.

3. You are now ready to connect iAUDIO to PC (Don’t run JetShell at this time).

Connect the USB ports of

iAUDIO to your PC using the provided

USB cable.

(We recommend to connect

iAUDIO to the PC directly, not using USB hub)

4. As soon as the cabe is connected, the message “Found New Hardware” appears and the USB

driver for iAUDIO is installed automatically. The driver installation message may not appear on the

screen depending on the status of Windows. To make sure that the installation was completed nor-

mally, check for the device “iAUDIO” in My Computer as shown below, or “Control Panel -> System

-> Hardware -> Device Manager”.

5. Now you can transfer ﬁ les by using JetShell or Window Explorer.

Connecting iAUDIO and Installing JetShell

Downloaded from www.Manualslib.com manuals search engine