User guide

iAUDIO 4
14
iAUDIO 4
15
Loading the Battery/Connecting USB Cable
Connecting USB Cable
Unlike when replacing the battery, push
the back cover in the direction of the arrow
until it stops. The built-in USB port appears
and the cover is xed.
Be careful about the direction of the USB cable
when connecting iAUDIO with the computer.
For Windows XP, it is OK to disconnect the
USB cable after the transfer window is closed.
For Windows 2000, however, you should
run ‘Safely Remove Hardware’ before
disconnecting the cable.
When downloading a le, make sure that
the status has changed to READY on the
iAUDIO LCD window before disconnecting
the cable.
Loading the Battery
1. Push down the battery cover on the back
of iAUDIO 4, slide the cover down and
pull it out toward you to remove it.
2. Insert the - /negative pole of the AAA size
battery into the top of the battery compartment
where there is a spring, and then put the +
/positive pole into the bottom.
3. Push the cover from the bottom to the top in the
reverse order of opening it.