Operation Manual

iAUDIO M3

Basic Operations

1. Power On/Off

• When you connect the power cable or press the "PLAY" button for a few seconds, the "iAUDIO" logo

appears and the power comes on.

• To turn the power off, press the "PLAY" button for a few seconds again. (Power cannot be turned off

during recording or in the USB mode.)

• If the AC Power Adapter is connected when you turn the power off, the charge window is displayed and

iAUDIO goes into Charge mode.

• To use iAUDIO again in the Charge mode, press the "PLAY "button for a few seconds again.

• When you set "Auto Off" or "Sleep Timer", the power automatically turns off.

2. Charging

• To recharge the battery, connect the AC Power Adapter to iAUDIO. (iAUDIO will then turn on

automatically if it was off.)

• The iAUDIO’s "CHARGE" LED lights up while the battery is being charged, and goes off when it is fully

charged.

• If you turn the power off while the AC Power Adapter is connected, the "Charge" window appears and

iAUDIO goes into Charge mode. The battery will recharge to 90% capacity after two hours.

• In Charge mode, when recharging nishes, the "Charge Complete" window appears and the MODE LED

of iAUDIO lights up in bluish green.

• The battery is also charged when the USB cable is connected.

(The charging speed is slower than using AC Power Adapter)

3. Connecting USB Cable

■ Connecting USB Cable

When you connect the USB cable to the PC while iAUDIO is turned on, used or charged, it enters USB Mode.

(iAUDIO cannot enter USB Mode while recording.)

When the USB cable is connected, the built-in battery is not used and the USB supplies electric power.

When you connect iAUDIO to a USB hub that supplies low current (e.g., a hub installed in the keyboard

or monitor), an error message may appear and iAUDIO may not work normally.

■ Disconnecting USB Cable

• First, run "Safely Remove Hardware" wizard from the Windows tray.

When "OK to disconnect" appears on the LCD window of iAUDIO, disconnect the USB cable.

• If the AC Power Adapter was not connected, iAUDIO automatically powers off.

• If the AC Power Adapter was connected, iAUDIO automatically enters Charge mode.

• When you press the "PLAY" button for a few seconds in the Charge mode, iAUDIO is rebooted.

You should always reboot iAUDIO because the music les in HDD are searched during the rst booting after

the USB cable is disconnected. This takes some time if there are many music les. (20 to 25 seconds if the

HDD is full.)

Basic Operations

Power On/Off, Charging & Connecting

Press for a few

moments

Charge in Progress Charge Completed Connecting to PC via USB cable Safely Disconnect from PC

Press for a few

moments

Downloaded from www.Manualslib.com manuals search engine