Use and Care Manual
Table Of Contents
- When using electrical appliances, basic safety pre
- CAUTION – Risk Of Fire Or Explosion. Flammable Re
- CAUTION-Risk Of Fire Or Explosion Due To Puncture
- If the unit is with problem need to be maintained,
- WARNING:This appliance is intended to be used in h
- IMPORTANT:
- To avoid a hazard due to instability of the applia
- SPECIFICATIONS
- WATER CONNECTION FOR YOUR ICE MAKER
- CLEANING & MAINTENANCE
10
Electrical Shock Hazard
Plug into a grounding wall outlet.
Never remove the ground prong.
Use a separate power supply or receptacle.
Never use an adapter.
Never use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
ELECTRICAL REQUIREMENT & CONNECTIONS
WARNING: THIS UNIT MUST BE EARTHED.
Before you move your ice maker into its final location, it is important to make sure you have the proper
electrical connection.
It is recommended that a separate circuit, serving only your ice maker, be provided. Use receptacles
that cannot be turned off by a switch or pull chain. If the supply cord or plug is to be replaced, it should
bedone by a qualified service engineer.
This appliance requires a standard 110-120Volt, 60Hz electrical outlet with good grounding means.
Recommended grounding method
For your personal safety, this appliance must be properly grounded. This appliance is equipped with a
power supply cord having a grounding plug. To minimize possible shock hazard, the cord must be
plugged into a mating grounding-type wall receptacle, grounded in accordance with the National
Electrical Code and local codes and ordinances. If a mating wall receptacle is not available, it is the
personal responsibility of the customer to have a proper grounding wall receptacle installed by a
qualified electrician.
Before using your ice maker, it is strongly recommended to clean it thoroughly.
1.
Open the ice-getting door.
2.
Clean with diluted detergent, warm water and a soft cloth.
3.
Repeatedly clean the water contacting inner parts, you can pull the Water drain pipe of the water
tank indicating “H” in above illustration to drain the cleaned water in the water tank, then next to
clean inner ice-storing cabinet, till all of inner parts are cleanly, then drain out all of the cleaned
water from the water drain port located at unit back indicating “7”in above illustration. And must
reinstall back the water drain pipe of the water tank and the cap of the unit water drain port,
otherwise, the unit will not make the ice normally. And suggest that you should discard the
ice-cube made during the first ice-making cycle after cleaning.
4.
The outside of the ice maker should be cleaned regularly with a mild detergent solution and warm
water.
5.
Dry the interior and exterior with a clean soft cloth.