Use and Care Manual

11
WATER CONNECTION FOR YOUR ICE MAKER
Important: Be sure to use the new hose-sets supplied with the appliance to
connect to water mains and that old hose-sets should not be reused.
1. Connect the water supplying hose to the unit
Step 1: First remove the tape on the water inlet port for water supply (indicated in the following
illustration “B”) located at unit back, then use your other hand’s finger to press the out circle.
Step 2: Insert the one end of the white water hose into the water inlet port, and push inward completely,
and install back the clipper, then water hose connection is completed.
STEP 1: Remove the tape
STEP 2:Insert the water tube
Water inlet port on the
unit back
Then install the
clip back
Remove the clip first
2. Connecting the water drain pipe
White water
tube(accessory)
Insert water tube
inward completely
about 15mm depth
Pull out the water drainage cap with black color (indicated “A” in above illustration), then
connect the white drainage pipe included in accessory, again connect the other end of this drainage to
the main water drainage pipeline.
3. Connect the water hose to the water faucet of the water main supply system
First, install the supplied water quick-connector to the water faucet by screw thread; Second, remove the
clipper from the water quick-connector, insert the other end of the water hose into this quick-connector
port completely, then install back the clipper, also this step is completed.
Note: The water faucet should be supplied by the customer himself.
Important: The water pressure of main water supply system must be 0.04-0.6 MPa at least.
A
B