Use and Care Manual
Table Of Contents
- When using electrical appliances, basic safety pre
- CAUTION – Risk Of Fire Or Explosion. Flammable Re
- CAUTION-Risk Of Fire Or Explosion Due To Puncture
- If the unit is with problem need to be maintained,
- WARNING:This appliance is intended to be used in h
- IMPORTANT:
- To avoid a hazard due to instability of the applia
- SPECIFICATIONS
- WATER CONNECTION FOR YOUR ICE MAKER
- CLEANING & MAINTENANCE
12
OPERATING YOUR UNIT
Operation Button and Display Area Diagram
THE ICE MAKING PROCESS
1.
Starting up: Plug in the power plug, and the symbol will flash in the display window. Press the
ON/OFF button on the control panel. The machine will start to make ice when the external pipe adds
water to reach the standard level on the water tank through the electromagnetic water valve.
Thereafter, the symbol will remain bright constantly in display window and symbol
will rotate.
The ambient temperature will be displayed on the upper left of the display screen.“80°F”means
the ambient temperature is 80°F. Several minutes later, the flashing numbers will be displayed in the
ambient temperature display area, and the flashing number“10M” means the unit still needs 10
minutes to finish this ice making cycle.
2.
After the ice making cycle is finished, the unit enters the deicing process, and the symbol flashes.
Next, the external pipe adds water to the water tank through the electromagnetic valve, and the
arrow on the symbol will flash until the water reaches the standard level. Finally, the symbol
extinguishes, and the unit enters the next ice-making cycle. When the water cannot reach the
standard level, the symbol is always bright, and the unit stops working. Restart the unit if there is a
water shortage; otherwise it will start up automatically after 15 minutes.
Note: Each ice-making cycle is around 11-20 minutes. The ice-making time will be changed
according to the ambient temperature and the water temperature, especially in the first ice-
making cycle. The ice-making cycle will be longer because of the high water temperature in
the water tank, but it will not be over 30 minutes.
3.
Adjust the ice thickness: Press the “+” and “-” button on the control panel to adjust the ice
thickness. The number in the left bottom of the display panel is the setting of the ice-making time,
and the default setting is “0”. To produce thicker ice, add one minute of ice-making time by pressing
“+” button once; in contrast, to produce thinner ice, reduce one minute of ice-making time by
pressing "-" once. Restart the machine and it will go back to the default setting of “0”.
Note: The time currently set only changes the next ice-making cycles.
4.
When the symbol lights up, the machine stops working, and it will work again after you take out
the ice.
5.
Shut down the unit
:
During the ice-making process, press the “ON/OFF” button on the control