Use and Care Manual
Table Of Contents
- When using electrical appliances, basic safety pre
- CAUTION – Risk Of Fire Or Explosion. Flammable Re
- CAUTION-Risk Of Fire Or Explosion Due To Puncture
- If the unit is with problem need to be maintained,
- WARNING:This appliance is intended to be used in h
- IMPORTANT:
- To avoid a hazard due to instability of the applia
- SPECIFICATIONS
- WATER CONNECTION FOR YOUR ICE MAKER
- CLEANING & MAINTENANCE
18
The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner
products.
Use rubber gloves to protect hands. Carefully read the material
safety instructions on the container of the ice machine cleaner.
8. Then open the water faucet of the main water supply, Let the water flow in the unit.
Again press the
“
TIMER CLEAN
”
button on control panel for more than 5 seconds,
to enter the self-Cleaning program. Same as the above explanation, the water
pump runs for 8 minutes and stops for 3 minutes, one cycle after one cycle. The
total duration time is 30 minutes for one self-cleaning program.
During this process, the “CLEAN”light will always be on, and the digit panel will
indicate the left time. Through this process, It will rinse the water dividing pipe,
evaporator, water pump, silicone pipe, water tank, etc.
9. After one self-cleaning program is complete, then pull out the drain pipe of the
water tank, drain the cleaning solution down to the lower ice storage bin, also
shake the unit slightly to drain out all of the water completely. Then install back the
drain pipe to the water tank slot tightly.
10. Repeat the step 8-9 again twice.
11. Following the above program to clean the ice storage bin .
12. After this special cleaning program is finished, you can return to the regular ice-
making mode. And suggest discarding the first batch of ice cubes.
Cleaning Suggestion
1) DAILY CLEANING
The ice shovel, door and the water dividing pipe should be cleaned by yourself each day. At the end of
every day, rinse the ice shovel and wipe both sides of the door with a clean cloth.
2) SEMI-MONTHLY CLEANING
The ice shovel, ice bin, water tank, the ice-full detecting plate and the surface of the evaporator are to
be cleaned by yourself semi-monthly according to interior cleaning program.
3) SEMI-ANNUAL CLEANING
All the components & surfaces exposed to water or ice cubes, like ice storage bin, water tank, door,
evaporator, water pump, silicone tube, water dividing pipe, etc. should be cleaned by Using Nu-
Calgon Nickle Safe Ice-machine Cleaner every 6 months. They should be cleaned by the
serviceman according to ice-making assembly system cleaning program.