Use and Care Manual

6
D. Water tank.
E. Water supplying pipe.
F. Cover board on the right side of the evaporator.
G. Water level switch installing plate.
H. Water drain pipe of the water tank：when ice-making, this pipe should be clamped in the slot
of the water tank wall; And when draining, this pipe should be pulled out.
I. Water pump.
J. Water level detecting switch.
3) Operation panel
A. “TIMER CLEAN” Button:
Quickly press this button once, to enter the Timer
setting program; And press this button for more than
5 seconds, to enter the Cleaning program.
B. “ON /OFF” Button:
When the unit is off, press this button to turn on
the unit; And during the Self-cleaning program, or
normal ice-making state, press this button to turn
off the unit at once; And also if the unit is set with
the Timer, press this button to cancel the Timer
setting. When the unit is making the ice cube,
press this button for more than 5 seconds, the
unit will switch to ice harvest process by force.
C. LCD Display Window:
1. Environmental temperature display and ice-making
time countdown display. Display ice-making time
countdown with M as the unit display, and display
environmental temperature with F as the unit
display.
2. Making ice and deice symbol display, the machine is making ice when the symbol rotate, and
the machine is deice when the symbol flash. .
3. Automatic self-cleaning symbol display
4. On/Off symbol display
5. Error code display: E1 means the environmental temperature sensor is damaged.
E2 means ice making is anomaly or the refrigerant leaked.
E means drain pump not work(Only if the unit have drain tank).
6. Water flowing and water shortage display. The arrow flashing indicates that the machine is in
the water, the whole symbol is bright to indicate that the machine is short of water.
7. Ice full alarm. The machine will making ice again when you take out the ice.
8. Setting display. Display timing switch machine with the H as unit display; Display ice making
time setting with M as unit display.
D&E. “+”、“-” Button:
Used to adjust the ice-making process duration period, the default setting is zero, 1 minute
adding or decreasing per pressing of “+” or “-” button.
Also to adjust the delay time of the timer, the default setting is zero, 1 hour adding or
decreasing per pressing of “+” or “-” button.