Product Manual

INSTALLATION AND MAINTENANCE MANUAL FORM #PM-122 REV A 12/09
Page 5 of 5
For assembly drawings, parts lists, or specific repair instructions, refer to web site at www.coxreels.com
or consult factory.
Coxreels, Inc., 5865 S. Ash Ave., Tempe, Arizona, USA, 85283 Tel: [phone]
TROUBLE CAUSE REMEDY
CABLE WILL NOT FULLY FIT ONTO
DRUM OF REEL
a) Cable is longer than specified.
b) Outside diameter of cable is larger than
specified capacity.
c) Cable was not hand guided onto reel
and wound up evenly on drum.
a) Cut down cable to meet reels specified capacity.
b) Replace cable with one that meets specified maximum
outside diameter requirements.
c) Hand guide cable onto drum as it is wound onto the
reel.
REEL KEEPS TURNING WHEN
OPERATOR STOPS PULLING OUT
CABLE
Tension drag brake is too loose causing
cable backlash
Adjust tension drag brake by turning knob clockwise.
NO ELECTRICAL CURRENT AT
OUTPUT END OF CABLE
a) Cable is severed
b) Slip ring brushes are worn
a) Replace cable
b) Replace slip ring brushes
c) Note: ensure current does not exceed rated amperage.