User's Manual

CDR-915 OEM DATA RADIO MODULE

___________________________________________________________________________________________

Revision O

INTEGRATOR’S GUIDE

Click on the “PC Settings” tab, then select which COM port will be used to connect to

the data radio. As shown below, ports COM1 thru COM4 are available. This setting will

be retained the next time the configuration program is run.

Getting Started

To configure the radio, click on the appropriate tab for the radio being configured. Then

select the radio Communications Port. The default setting is for asynchronous serial

mode, UART (Universal Asynchronous Receiver/Transmitter). The default baud rate is

9600 bits per second. The interface baud rate can be set to standard values between

2400 and 57600 as shown on the following page. This mode supports 8 data bits, 1

stop bit and no parity.