Quick Start Guide

ManualsBrandsCoyote ManualsGrill Side BurnersCoyote Stainless Steel Natural Gas Side Burner

C1CSB LP/NG Installation Guide

C1CSB LP/NG INSTALLATION GUIDE

STEP 1

• Remove the right side shelf from the cart

• The side shelf is supported by 4 screws - accessible from the bottom side

STEP 2

• Install 4 new bolts as well as the grommet provided (see picture 1) but do not tighten

the bolts yet as the new side burner will rest on them in STEP 4

STEP 3

• Remove the C1CSB control knobs

• Remove the front panel by removing the 2 screws on the top and 2 screws at the

bottom (see pictures 2 & 3)

(picture 1)

(picture 2)

(picture 3)

Summary of content (3 pages)

PAGE 1
C1CSB LP/NG INSTALLATION GUIDE STEP 1 • Remove the right side shelf from the cart • The side shelf is supported by 4 screws - accessible from the bottom side STEP 2 • Install 4 new bolts as well as the grommet provided (see picture 1) but do not tighten the bolts yet as the new side burner will rest on them in STEP 4 (picture 1) STEP 3 • Remove the C1CSB control knobs • Remove the front panel by removing the 2 screws on the top and 2 screws at the bottom (see pictures 2 & 3) (picture 3) (picture 2) C1
PAGE 2
STEP 4 • Install the side burner body on the cart by hooking and latching the burner onto the cart’s screws installed in STEP 2 (see picture 4) (picture 4) STEP 5 • Tighten the bolts that hold the C1CSB onto the cart o Screws are accessible on the back at locations A and B (see picture 5) and locations C and D on the front (see picture 6) (picture 5) (picture 6) STEP 6 • Reinstall the C1CSB control panel by reattaching the 2 upper screws and 2 lower bolts shown on step 3 C1CSB LP/NG Installation Guide
PAGE 3
STEP 7 • Install the new piping assembly (shown in picture 7) for the C1CSB and grill consisting of: o (1) 1/2” nipple x 3/8” nipple o (2) 1/2” tee o (3) 1/2” nipple x 3/8” nipple o (4) 1/2” nipple x 3/8” nipple (picture 7) FINISHING THE INSTALL: • Pressure test all fittings with soapy water to ensure that no LP or NG gas leaks are present • Finish by closing off and re-installing all panels on the back side of the C1CSB and the grill unit • Your C1CSB is ready for use *** Note: This is just an installat