Installation Sheet

www.coyoteoutdoor.com
C1EL120SM INSTALL GUIDE
 Installation of this grill must meet the location requirements shown in the above installation illustration
 All dimensions listed are minimum requirements for safe operation
 Failure to locate the grill without proper clearances will result in a fire hazard
 For built-in situations, a minimum height clearance of 6-1/4" is required from the top of the counter top to any combustible material below the
grill.
 This grill is approved for indoor or outdoor use, however a ventilation hood is always recommended for use indoors to provide additional air
circulation
 Ventilation of any built-in enclosure is required for safety. Refer to your state, municipal and local codes for required specifications
 The grill should be installed by a qualified installer or technician that can follow all stated instructions within this guide and the owners manual
of the grill
Important Note to Installer: This file is not intended to replace your Owners' Manual which contains specific safety
requirements and consumer guidelines. Please refer to your Owners' Manual prior to installing or operating your built-in grill.
 Maximum depth of overhead cabinets can be 13”
 Minimum height of countertop from floor should be 36”
 The minimum flat countertop surface that the grill will rest upon must be equal to or greater than the overall grill dimensions
 30” minimum clearance between the top of the grill and the bottom of an unprotected wood or metal cabinet OR 24” minimum clearance
when the bottom of wood or metal cabinet is protected by not less than 1/4” thick flame retardant mill board covered with not less than No.
28 MSG sheet steel, .015” thick stainless steel, .024” thick aluminum or .020” thick copper
 4” minimum from backsplash of countertop to edge of grill. 1-1/2” minimum from front of counter to grill
18" min
36"
FLOOR TO
COUNTERTOP
30" min
COUNTERTOP
TO COMBUSTIBLE
MATERIALS
SEE COUNTERTOP
CUT-OUT TOP RIGHT
2"
2"
TO COMBUSTIBLE
SIDE
CABINET
13"
max
FRONT VIEW
SIDE VIEW
16"
CUT-OUT WIDTH
COUNTERTOP CUT-OUT
FRONT
15"
CUT-OUT
DEPTH
1
1
/2" min
4" min
REAR - BACKSPLASH
Electrical Requirements:
Installation Requirements:
Clearance Requirements:
 This electric grill must be installed in accordance with National Electric Codes, as well as state, municipal and local codes
 The correct voltage, frequency and amperage must be supplied to the grill from a dedicated grounded circuit which is protected by a properly
sized circuit breaker or time delay fuse.
 The proper voltage, frequency and amperage ratings are listed on the product rating plate.
 The grill must be properly grounded at all times when electrical power is applied
TO COMBUSTIBLE