Use and Care Manual

1019061-BPage 11
Sight Glass Cover
Pilot
Sight Glass
A. This appliance has a pilot which must be
lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next
to the oor because some gas is heavier
than air and will settle on the oor.
WHAT TO DO IF YOU SMELL GAS:
• DO NOT try to light any appliance.
• DO NOT touch any electric switch.
• DO NOT use any phone in your building.
• Immediately call your gas supplier from
a neighbor’s phone. Follow the gas
supplier’s instructions.
FOR YOUR SAFETY READ BEFORE LIGHTING
MODELS: CDV155D / CDV156D / CDV255D / CDV256D / CDV305D / CDV306D
• If you cannot reach your gas supplier, call
the re department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob
will not push in or turn by hand, don’t try to
repair it, call a qualied service technician.
Force or attempted repair may result in a
re or explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualied service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
6. Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. 
 Follow “B” in the safety information on
the safety label. If you don’t smell gas, go to the
next step.
7. Open sight glass cover.
8. Locate red piezo ignitor button inside gas control
compartment. Locate pilot behind sight glass. (Follow
metal pilot tube from gas control).
 Turn gas control knob counterclockwise
to
“PILOT”.
LIGHTING INSTRUCTIONS
WARNING:
If you do not

instructions



causing
property

personal
injury or loss
of life.
LIGHTING INSTRUCTIONS
TURNING OFF GAS TO APPLIANCE
 Read the information on the safety label.
 Set thermostat to lowest setting.
 Turn off all electric power to the appliance.
4. Remove cabinet.
 Push in gas control knob slightly and turn clockwise
to “OFF”.
1. Set the thermostat to it’s lowest setting.
 Turn off all electric power to the appliance if service is
to be performed.
 Open cabinet door.
4. Push in gas control knob slightly and turn clockwise
to “OFF”. Do not force.
 Close cabinet door.
 Push in gas control knob and hold in. Immediately
begin a series of pushing and releasing the red piezo
ignitor button, while observing the pilot through the
sight glass. Continue to spark until pilot is lit. Continue
to hold the gas control knob in for about one (1) minute
after the pilot is lit. Release the gas control knob and
it will pop back up. Pilot should remain lit. If pilot goes
out, repeat steps 4 thru 9.
• If knob does not pop up when released, STOP and
immediately call your service technician or gas supplier.
• If the pilot will not stay lit after several tries, turn the gas
control knob to “OFF” and call your service technician
or gas supplier.
11. Close sight glass cover.
 Turn gas control knob counterclockwise
to “ON”
 Replace cabinet.
14. “Turn on all electric power to the appliance”.
 Set thermostat to desired setting.
IN
PILOT ADJ
NOTE:
Knob cannot
be turned from
“PILOT” to
“OFF” unless
knob is pushed
in slightly.
Do not force.
Gas Control Knob