Use and Care Manual
Page 14 1019061-B
FIG. 13: Wiring Diagram
SERVICE RECORDS
MAINTENANCE
TO REMOVE MAIN BURNER FOR
INSPECTION AND CLEANING
1. Remove outer casing.
Disconnect gas supply to valve.
Remove 11 screws holding burner door to heat
exchanger and lift out complete burner, valve assembly.
4. After inspecting burner, place back into heat exchanger.
Be sure door gasket is not damaged & will effect a
proper seal or pilot outage will occur.
Tighten screws holding burner door to heat exchanger.
6. Connect gas supply back to valve.
7. Install front panel and follow lighting instructions.
IN
PILOT ADJ
IN
PILOT ADJ
Pilot Generator Leads Thermostat Wire
!
CAUTION:
NOTE: The furnace and all components must be inspected at least annually by a qualied service technician. This should
include the burner, heat exchanger, and vent system. Be sure that the ow of combustion and ventilation air are not obstructed.