Full Product Manual

1018454-EPage 11
INSTALLATION
A
B
Install on the right
side OR left side of
the housing.
A
B
C
C
30
30
STEP10.
- Remove the door from the heater housing.
- Locate the Pilot Pro in the carton and remove the cover from
baseplate with a screwdriver.
- The Pilot Pro may be installed near the base of either side of the
heater housing. When selecting a side for installation, be sure to
allow room for future removal of the pilot pro cover.
- Check the inside of the housing for safety labels. Try to avoid drilling
through any pertinent safety information during this step.
USE THE MOUNTING PLATE
(
30
)
FOR THE
FOLLOWINGSTEPS.MOUNTINGPLATEMUSTBE
MOUNTED AS DIRECTED BELOW OR WIRE HARNESS
WILLNOTREACH.
 1. PLEASENOTE
A
OFTHISSTEP.
Do not mount the PilotPro any higher than the top of the
access door of the housing.
 2. PLEASENOTE
B
OFTHISSTEP.
Align the PilotPro very close to the back edge of the housing.
 3. PLEASENOTE
C
OFTHISSTEP.
Be sure to face the notch / cutout of the mounting plate (30)
toward the wall.
4. Using the mounting plate (30) as a template, align in place as
illustrated. Using a marker or pencil, leave a mark for the three
hole locations on the metal housing.
SET ASIDE THE MOUNTING PLATE
(
30
)
.
5. Drill the three holes into housing using a 3/16” drill bit.
DO NOT DRILL DIRECTLY THROUGH MOUNTING PLATE.
DRILL MAY CRACK THE MOUNTING PLATE.
WALL
WALL
Left
Sideof
Heater
WALL
WALL
Right
Sideof
Heater