Quick Manual
12
8
9
1
2
3
4
5
10
117
5. IP Installer4. Cabling
2
3
4
5
6
7
8
9
10
11
12
1. Run IP Installer
Run the manual CD and IP installer in
connected then click on a ‘Search’
Select a camera to set.
failed.
Input ID and PW of the camera for
Make sure to change the ID and PW for
security reason.
Users Management” for ID and PW change.
access to the camera.
An additional change of HTTPS, RTSP port
the camera.
or Factory Reset button.
6
DHCP mode.
is set to 192.168.1.80 after one minute.
Disposal of Old Appliance
2. All electrical and electronic products should be disposed of separately form the
4
1
2
3
Setup popup button. Click it to open
the Setup page to setup details of IP
System and etc.
When the image goes unsmoothly
it stored image during setup time and
PTZ Control
and focus.
Supported.
setup time.
5
6
Camera Time. Display the camera time.
7
PIR. The maximum number of counters is
99.
8
Auto Clear. If you press the Auto Clear
button, it is automatically cleared after a
certain time after PIR motion occurs and
the counter does not increase.
button.
2
3
8
4
7
1
5
6
FCC ID : 2AX2S-NST8-22-R
1
2
3
3
2
Network Connec�on
1
Power Connec�on
Rated
Consumption
DC 12V 3.96W
Class3
Alarm In
Alarm Out
Deice Setup State Input eel Value
N.O Close 0V ~ 2.3V 1
2.3V ~ 3.3V 0
N.C Open 0V ~ 1.0V 0
1.0V ~ 3.3V 1
Superisor Up 0V ~ 1.0V 0
1.0V ~ 2.5V 1
2.5V ~ 3.3V 2
Don 3.3V ~ 2.3V 2
2.3V ~ 0.8V 1
0.8V ~ 0V 0
Preparing to mount the camera
1. The mounface museight of your camera.
2. Do not let the cables get caught in improper places or the electric line coer to be damaged.
This may cause a breakdore.
3. CArsre for use brrsonnel only. To reduce the risk
of electric shock do not perform any serat contained in the operas
unless you arto do so.
6. Unit is intended for installaetnronment 0 as deC TR 62102. As such,
associated therneted to inside the building.
7. Using the mountemplate sheet or the camera itself, mark and drill the necessary holes in the all
or ceiling.
FCC Compliance Statement
FCC Cau�on
FCC Radia�on Exposure Statement
FCC Interference Statement