Technical data

29
Figure 3-23 Take off the cover of the wiring box
2) Knock out the holes of the DC side and plug the suitable conduits of
1-1/4 or 1 inch through the holes. Then put the cables through the
conduit inside the wiring box.
3) The inverter supports 3 kinds of cable connection on the AC side
depending on the grouding connection method. The cable set-up procedures
are illustrated below.
Table 3-6 Necessary tools for cable set up
No.
Tools
1.
4mm (0.16in.) flat screwdriver
2.
8mm hex socket wrench
3.
Diagonal pliers
4.
Wire stripping pliers
5.
Crimping pliers
Table 3-7 Torque value
AC output terminal block
1.2 N-m
Internal grounding bar
1.6 N-m
Internal grounding stud
1.6 N-m