Technical data

4. “MPPTCycle” is used to set up the cycle time of MPPT Scan. Move the

cursor to this menu, press ENT to set up the cycle time. Use UP and DOWN to

adjust the MPPT cycle time. Press ENT to confirm the setting.

5. “MPPTScan” is to execute the MPPT scanning manually. Move the

cursor to this menu, and press ENT to initiate the scanning. The LCD screen

will skip to normal operation interface if the MPPT scanning succeeds, but

remain on the “MPPTScan menu” interface if the scanning fails.

(7) Configure the network address in the “7 NetConfig” menu.

Move the cursor to the menu, press ENT and set up the parameters by

UP and DOWN.

5.4.5 Power dispatch

Move the cursor to “5 Dispatch” in the main interface and press ENT to go

to the following interface (Figure 5-13):

5 Dispatch

ActivePower(%)

100.0

PowerFactor

1.000

Figure 5-13 Active Power and PowerFactor

Remote power dispatch: The “ActivePower” and “PowerFactor” can be

adjusted remotely by software.

INSTRUCTION:

Move the cursor to the corresponding menu to set up the

parameters, and the number will flash after pressing ENT. Use UP

and DOWN to adjust the parameters.