MSDS

Page 2 of 6 DIRECT FIRE CRACK & JOINT SEALANT
CARCINOGENIC: N/A
Asphalt Cement,
CAS #8052-42-4 % By WT:100%
Listed in SARA Title III, Section 313: No
OSHA PEL: 10 ppm
ACGIH TLV: 5 mg/m
3
(volatiles)
STEL: N/A
LC50: N/A
LD50 N/A
N/A = Not available or applicable
Ingredients total weight % are below 100% only if all others unlisted are not considered hazardous by any federal
(OSHA, WHMIS, SARA), any state or province, or local Right-To-Know regulations.
EMERGENCY AND FIRST AID PROCEDURES:
Eyes: Hot materials may cause burns. Immediately flush with clean water for 15 minutes
while holding eyelids open, consult a physician.
Inhalation: If overcome by mist or vapor, remove from exposure immediately; call a physician.
If breathing is stopped or irregular, start resuscitation, administer oxygen.
Skin: Remove any contaminated clothing and wash skin with soap and warm water.
Vegetable or mineral oil can remove dry material. Do not use solvents or thinner to
clean skin
Ingestion: INDUCE VOMITING! Prevent aspiration of liquid into lungs Get immediate
medical attention
FLAMMABILITY CLASSIFICATION: Not Regulated
FLASH POINT: 424° F minimum
AUTO IGNITION TEMP.: N/A
LOWER EXPLOSIVE LIMIT (LEL): 1.0
UPPER EXPLOSIVE LIMIT (UEL): 6.0
COMBUSTION PRODUCTS:
Hydrogen Sulfide, Sulfur Dioxide, Carbon Monoxide, Carbon Dioxide and other unidentified
hydrocarbons
EXTINGUISHING MEDIA:
Class B fire extinguishing media such, as but not limited to: Halon, CO
2
, or dry chemical
SPECIAL FIRE FIGHTING PROCEDURES:
Fire fighters should wear self-contained breathing equipment in addition to normal personal protective
equipment. Do not allow run off from fire fighting procedures to enter public waterways.
Section III – COMPOSITION
Section IV – FIRST AID MEASURES
Section V – FIRE-FIGHTING MEASURES