MSDS

Page 3 of 6 DIRECT FIRE CRACK & JOINT SEALANT
Avoid using solid water streams. Water spray and foam must be applied carefully to avoid frothing.
Use water to cool surfaces
UNUSUAL FIRE AND EXPLOSION HAZARDS:
Hot materials may ignite flammable materials on contact. Use adequate ventilation with clean-up
procedures.
NFPA RATING: HEALTH: 1 FIRE: 1 REACTIVITY: 0
Hazard Scale: 0 = Minimal 1 = Slight 2 = Moderate 3 = Serious 4 = Severe
UN/NA/PIN#: N/A
IMPACT SENSITIVE: No
STATIC SENSITIVE: No
EXPLOSIVE POWER: N/A
BURNING RATE: N/A
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:
Remove all ignition sources. Ventilate the area. Wear suitable protective clothing, gloves &
eye/face protection. Put in a sealed approved container. Scoop up for reuse or disposal. Dispose
of in accordance with federal, state and local regulations.
WASTE DISPOSAL METHOD: Dispose in accordance with federal, state and local regulations.
REPORTABLE QUANTITIES (lbs): N/A TPO (lb): N/A
REGULATIONS: WHMIS, SARA, state and province HAZARDOUS WASTE: N/A
Handling: For hot material, avoid eye contact, repeated or prolonged skin contact or inhalation of vapors.
Wash thoroughly after handling. Use in well ventilated areas.
Storage: Keep container closed when not in use. Do not store in open, unlabeled or mislabeled containers.
Unheated material presents no known hazards. Store in areas where sources of ignition have been eliminated from
vicinity of stored products.
Personal protective equipment pictograms:
VENTILATION:
Section VI – ACCIDENTAL RELEASE MEASURES
Section VII – HANDLING AND STORAGE
Section VIII – EXPOSURE CONTROLS / PERSONAL PROTECTION