Specification

Dalton Enterprises, Inc., 131 Willow Street, Cheshire, CT 06410
Phone [phone] • Fax [phone] • www.latexite.com
Revised 09/28/16
TECHNICAL DATA SHEET
CRACK·STIX
®
Model #: 2050 UPC#: 090932501508
Med 125ft of ½ inch (12.7mm) diameter
Model # 2060 UPC#: 090932020603
Small 250ft of ¼ (6.3mm) inch diameter
Appearance:
Black solid
Maximum VOC:
0 g/L
Application Temperature:
32°F and rising
Specific Gravity:
N/A
Viscosity:
N/A
Weight Per Gallon:
See below for package weight
Color:
Black
Consistency:
Solid
Melting Point:
225°
Cure Time (50% relative humidity, 70º F):
20 minutes
Freeze ability:
N/A
Container Size & Weight:
2 gal container 2050 = approx. 10 lbs / 2060 = approx. 8 lbs
CRACK·STIX
®
is the only PERMANENT solution to cracks on the marketplace. It is the same product seen on highways and
roads but the only difference is YOU CAN APPLY IT and don't need a 200 gallon melter to do it! CRACK·STIX
®
is furnished as
a solid "rope" in ½" thickness. It is an elastomeric, self-leveling sealant, which liquefies quickly and can be used in both asphalt
and concrete pavements. When properly applied, it combines tenacious adhesive power with extraordinary resiliency to protect
against the infiltration of moisture through repeated thermal cycles of expansion and contraction. CRACK·STIX
®
exhibits
superior low temperature ductility, weather resistance, low oxidation breakdown and is non-tracking. It is the only sealant
available which is designed to be inserted into the crack or joint cavity first and then melted with direct heat process. The
modifier system contained in CRACK·STIX
®
allows the material to withstand direct heat without experiencing degradation.
(Note: Pli-Stix
®
and Crack-Stix
®
is the same product. Pli-Stix
®
comes in 30ft rolls, while Crack-Stix
®
comes in a 125 ft. roll.)
CRACK·STIX
®
is a simple and clean process. Before applying the product, it is important to thoroughly clean out the crack and
remove any loose debris. Use a screwdriver and whisk broom. Rinsing the crack and allowing it to dry will give you the best
results.
Now you are ready to install the CRACK·STIX
®
. Simply place the CRACK·STIX
®
into the crack (do not remove the plastic
wrap from the CRACK·STIX
®
). The CRACK·STIX
®
must be inside the crack so we recommend pushing the CRACK·STIX
®
into the crack using a screwdriver. (*Note: If the crack is not as wide as the ½" CRACK·STIX
®
, we recommend stretching
the CRACK·STIX
®
out...you can leave it in the sun for a while to make it easier to stretch. You can also splice it with a razor
blade). Once it's in simply light your torch (we recommend a Bernzomatic hand-held torch) and apply direct flame to the
CRACK·STIX
®
until it liquefies - this should take about 20- 30 seconds. Allow the CRACK·STIX
®
to set up for 20 minutes.
PHYSICAL PROPERTIES & PERFORMANCE
FEATURES
SURFACE PREPARATION
APPLICATION