Specification

Dalton Enterprises, Inc., 131 Willow Street, Cheshire, CT 06410, USA
[e-mail] • Phone [phone] • Fax [phone] • www.crackstix.com
Revised 3/15/2013
Meets or exceeds requirements of ASTM D412 - 06ae2 Standard Test Methods for Vulcanized Rubber and Thermoplastic
Elastomers—Tension and ASTM D1004 Tear Resistance of Plastic Film and Sheeting
100% Modulus
Ultimate Tensile
Elongation
(3 inch test, 7.6cm)
Tear Strength
35psi
135psi
1000%
66 lb/inch
CRACK·STIX
™
is the only PERMANENT solution to concrete joints and cracks on the marketplace. CRACK·STIX
™
are
furnished as a solid "rope" in 1/4” and 1/2” thickness. It is an elastomeric, self-leveling sealant, which liquefies quickly and can
be used in concrete and asphalt pavements. When properly applied, it combines tenacious adhesive power with extraordinary
resiliency to protect against the infiltration of moisture or incompressible through repeated thermal cycles of expansion and
contraction. CRACK·STIX
™
exhibit superior low temperature ductility, weather resistance, low oxidation breakdown and is
non-tracking. It is the only sealant available which is designed to be inserted into the crack or joint cavity first and then melted
with direct heat process. The modifier system contained in CRACK·STIX
™
allows the material to withstand direct heat without
experiencing degradation.
CRACK·STIX
™
is a simple and clean process. Before applying the product, it is important to thoroughly clean out the joint or
crack and remove any loose debris. Rinsing the crack and allowing it to dry will give you the best results.
Now you are ready to install the. CRACK·STIX™. Simply place the CRACK·STIX™ into the crack (do not remove the plastic
wrap from the CRACK·STIX™). CRACK·STIX™ must be inside the crack so we recommend pushing the CRACK·STIX™
into the crack using a screwdriver. (*Note: If the crack is not as wide as the ½" CRACK·STIX™, we recommend
stretching the CRACK·STIX™ out...you can leave it in the sun for a while to make it easier to stretch. You can also splice it
with a razor blade). Once it's in simply light your torch (we recommend a Bernzomatic hand-held torch) and apply direct flame
to the CRACK·STIX™ until it liquefies - this should take about 20 - 30 seconds. Allow the CRACK·STIX™ to set up for 20
minutes. CRACK·STIX™ can be sealed over once properly set up.
Avoid applying when temperatures drop below 32º F, 0º C. Allow all repaired surfaces to cure 24 hours prior to sealing. If the
joint or crack filler is firm you may seal over. Protective clothing and eyewear should be used during application.
To remove CRACK·STIX
™
, heat and scrape off excess material.
FEATURES
SURFACE PREPARATION
APPLICATION
PRECAUTIONS
CLEAN UP & STORAGE