Operation Manual

Spanning Tree Protocol (STP) allows a network design to include redundant paths while preventing broadcast radiation
from bridge loops.
Enable STP: Enable Spanning Tree Protocol loop detection.
Bridge Priority: Set the priority of the bridge. When determining the root bridge of the spanning tree topology, the bridge
priority is compared first. The bridge with the lowest priority value will have priority. If you want this router to be the root
bridge, then set it to a value less than the default of 32768. A valid priority value is between 0 and 65535.
Wired 802.1X
Wired 802.1X: (requires hardware version 2.0) This allows you to configure an authentication server that will accept
authentication requests from devices attached to wired Ethernet ports. IEEE 802.1X defines the encapsulations of the
Extensible Authentication Protocol (EAP).
Click Enable 802.1X to require IEEE 802.1X authorization for the Ethernet ports associated with this network.
Reauthentication Period: EAP re-authentication period in seconds.
Authentication settings
Auth Server IP Address: This is the IP address of the connected RADIUS server.
Auth Server MAC Address: This is the hardware address of the connected RADIUS server’s interface. NOTE: If
103