Operation Manual

Name: Give a name for your rule that is meaningful to you.
DSCP (DiffServ): Differentiated Services Code Point is the successor to TOS (Type of Service). Use this field to select
traffic based on the DSCP header in each IP packet. This field is sometimes set by latency sensitive equipment such as
VoIP phones. If you know specific DSCP values, you can input one here.
DSCP Negate: When checked this rule will match on any packet that does NOT match the DSCP field.
Protocol: Select from the dropdown list to specify the protocol for a particular data use. Otherwise, leave “Any” selected.
Any
ICMP
TCP
UDP
GRE
ESP
SCTP
Source IP Address, Source Netmask, Destination IP Address, and Destination Netmask: Specify an IP address or
range of IP addresses by combining an IP address with a netmask for either “source” or “destination” (or both). Source
vs. destination is defined by traffic flow. Leave these blank to include all IP addresses (such as if your rule is defined by
a particular port instead).
EXAMPLE: If you want to associate this rule with your guest LAN, you could input the IP address and netmask for the
guest LAN here (leaving the last slot “0” to allow for any user attached to the guest network):
161