Operation Manual

First – Use the first IPv6 prefix found
Static – Always use a static IPv6 translation (input the prefix here)
Transitioning from short prefix to a longer prefix (such as from /48 to /64) is not without problems, as some of the LANs
may lose IPv6 connectivity.
Port Forwarding Rules
A port forwarding rule allows traffic from the Internet to reach a computer on the inside of your network. For example, a
port forwarding rule might be used to run a Web server.
NOTE: Exercise caution when adding new rules as they impact the security of your network.
Click Add to create a new port forwarding rule, or select an existing rule and click Edit.
Add/Edit Port Forwarding Rule
Name: Name your rule.
Enabled: Toggle whether your rule is enabled. Selected by default.
Use Port Range: Changes the selection options to allow you to input a range of ports (if desired).
Internet Port(s): The port number(s) as you want it defined on the Internet. Typically these will be the same as the
local port numbers, but they do not have to be. These numbers will be mapped to the local port numbers.
Local Computer: Select the IP address of an attached device from the dropdown menu, or manually input the IP
address of a device.
Local Port(s): The port number(s) that corresponds to the service (Web server, FTP, etc.) on a local computer or
device. For example, you might input “80” in the Local Port(s) field to open a port for a Web server on a computer
within your network. The Internet Port(s) field could then also be 80, or you could choose another port number that
65