Operation Manual

disabled. Any wireless interfaces must be removed from this network in order to enable IP Passthrough. The

easiest way to enable IP Passthrough mode is with the IP Passthrough Setup Wizard (see Getting Started → IP

Passthrough Setup).

Hotspot: Provide Hotspot Services on this network, requiring Terms of Service or RADIUS/UAM authentication

before WAN access will occur on both wireless and wired LAN connections. To enable a Hotspot you must also

configure your Hotspot settings under System Settings → Hotspot Services.

Disabled: Disable this network.

IPv6 Settings

IPv6 must be enabled through the WAN initially: go to Internet → Connection Manager to enable IPv6.

IPv6 Address Source: By default, this is set to Delegated, which means the IPv6 address range for the LAN is passed

through from the WAN side. Change this to Static to input your own IPv6 address range here, or select None to

explicitly disable IPv6 LAN connectivity.

Interfaces