User's Manual

Revision 0.2 4 Jan 2016 Document Part: 170696-000
SAFETY, REGULATORY, AND WARRANTY GUIDE
CRADLEPOINT IBR600B-LP4 MODEL: S3A616A
CRADLEPOINT IBR650B-LP4 MODEL: S3A621A
This important Safety, Regulatory, and Warranty Guide contains safety, handling,
disposal, regulatory, trademark, copyright, and software licensing information.
Read all safety information below and operating instructions before using the
device to avoid injury.
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC STATEMENT
For product available in the USA/Canada market, only channel 1-11 can be
operated. Selection of other channels is not possible.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
To comply with FCC/IC RF Exposure Limits set forth for an uncontrolled
environment, the product must be installed and operated with a minimum
separation distance (between nearby person(s) and radiating antenna) according
to the following scenarios:
1. 21cm minimum when the product is operated alone without Dock device.
2. 23cm minimum when the product is operated with Dock device
3. For co-transmission scenario which is not covered above, please consult the
RF technician or device supplier.
This device and its antennas(s) must not be co-located or operating in
conjunction with any other antenna or transmitter except in accordance with
FCC multi-transmitter product procedures.
To comply with FCC regulations limiting both maximum RF output power and
human exposure to RF radiation, for the IBR600 and IBR650, the maximum
antenna gain in the cellular bands must not exceed 3 dBi. For the IBR600, the
maximum WiFi antenna gain must not exceed 5 dBi.
INDUSTRY CANADA STATEMENT
This device complies with Industry Canada license-exempt RSS standards.
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.