Instructions / Assembly

INSTALL RIGHT SIDE WALL PANEL

Important Note: The arrows on the label on the back of each panel indicate the TOP of the Panel.

1. Lay (4) Right Panel down on a ﬂat surface.

2. Based on your measurements from Step 1 (Measuring) cut the panel to the appropriate size and

make any required plumbing cut-outs according to the instructions in Step 2 (Cutting).

IMPORTANT: If you are using the optional corner trim or not, be sure to measure and cut appropri-

ately for the existing space needed to complete your corner. You may have to cut more or less of

the tongue to ensure proper ﬁt and ﬁnish.

3. Apply the double-sided tape and construction adhesive as explained in Step 3.

4. Peel o back of double-sided tape from the back of the beveled edge wall panel.

5. Position the panel at approximately 30 degrees, push the panel edge into the corner and then

carefully push the panel back towards the wall.

6. Press against the wall smoothing out any air bubbles along the entire area and then lightly tap on

wall panel with a rubber mallet from top to bottom to ensure it is tightly connected to the wall.

INSTALLATION PROCEDURE / STEP 8

- 11 -

OPTIONAL CORNER TRIM

Fill the channel of the corner

piece that the panel will ﬁt

into with caulk. Position the

panel at approximately 30

degrees, push the panel edge

into the channel and then

carefully push the panel back

towards the wall.