Instructions / Assembly

ManualsBrandsCRAFT + MAIN ManualsBathCove Sliding 48 in. L x 34 in. W x 78 in. H Center Drain Alcove Shower Stall Kit in Quarry and Brushed Nickel Hardware

- 12 -

INSTALLATION PROCEDURE / FINISHING

9

OPTIONAL: INSTALL EDGE TRIM

1. Measure and cut (2) Edge Trim for length and to

cover tile or existing wall material as needed.

2. Fill the channel that the wall panel will slide

into with caulk and apply construction grade

adhesive to the back of the Edge Trim piece.

Carefully position the Edge Trim and push it

into place.

2

2

10

CAULK CORNERS AND EDGES

Properly caulk around the Jetcoat® Shower Wall

System to insure a secure ﬁt and ﬁnish.

This includes but is not limited to:

• Interior corners where shower walls meet

(Not necessary if optional corner pieces

were used).

• Corners where the walls meet the base.

• Outer edge of Side Wall Panels (Not necessary

if optional edge pieces were used).

• (Optional) Caulking along the top edge of the

entire enclosure is not required but may help

contribute to a ﬁnished look.

Important Note: Please keep the entire area dry

for a minimum of 24 hours to allow the caulk and

construction adhesive to properly cure.

3

4

4

3