Manualshelf

Installation Guide

ManualsBrandsCRAFT + MAIN ManualsBathLagoon Dbl Roller 60 in Lx 30 in W x 78 in H Left Drain Alcove Shower Stall Kit in Driftwood and Brushed Nickel Hardware
12345678910
INSTALLATION PROCEDURE / STEP 1
1
- 4 -
MEASURING
1. Measure the height of installation area at both ends of each wall. From top of tub or shower pan to
the ceiling. If the ceiling height is less than the height of the panels included in your kit, the panels
can be cut down using the same cutting procedure outlined in Step 2.
2. Measure width of each wall at top and bottom of installation area.
Important Note: Steps 2 &3 will be repeated when installing each of the 5 wall panels.
Y
X
3. Measure cut-out locations for plumbing fixtures and mark them on the back of the appropriate
panel(s).