Owner`s manual

B2470 Tile Saw

Assembly

1. Slide the water tank through the slot in the machine frame so that the

entire tank rests inside the machine frame.

2. Mount the motor to the machine frame by connecting the supporting

frame to the machine frame at the point shown in the assembly

diagram on page 14. Secure using two bolts, washers and big flat

washers as shown.

3. Next attach the blade guard to the motor using the locking knob and

the flat washer provided.

4. Plug the pump into the back if the back of the motor and attach the

pump to the water tank using the four suction feet on the bottom of the

pump.

5. Slide the table holder through the middle of the rail cover and fit the

two inserts over the ends of the cover to prevent the table holder from

slipping out.

6. Attach the rail and table assembly you created to the frame using two

sets of bolts, flat washers and teeth washers as shown in the assembly

diagram.

7. Before operating this tile saw it must be mounted to the stand or

securely mounted onto a flat level surface capable of supporting the

weight of the tile saw in addition to the weight of all work pieces.

Changing /Installing the Blade

1. Power cord must be unplugged from its power source.

2. Loosen the locking knob located on the side of the blade guard and

raise guard. Tighten the knob to lock the guard in and up position.

3. Depress the brake shaft button (see Fig. 1 Page 11) while turning the

blade (or spindle if you have not yet installed the blade) with your hand

until the shaft button depresses fully. This will prevent the spindle from

spinning and allow you to unscrew the nut and outer flange.

4. Slide the new blade over the spindle, and refasten the outer flange and

nut. Be sure to tighten the nut fully before use.

5. Lower the blade guard and tighten the locking knob.

Note: Refer to page 11 for physical machine layout.