Owner`s manual

B2470 Tile Saw

Cutting Tile

1. Place your marked tile on the table and brace it against the upturned

edge (fence) on the back of the table. Align the cut mark with the

blade.

2. Once the tile saw has been turned on allow the blade to spin up to full

speed. Make sure the pump is supplying a continuous flow of water to

the blade.

3. Keeping your hands clear of the blade move the table and the tile

underneath the blade. Feed the tile underneath the blade very slowly.

Do not force it. If the rotation feed of the blade slows down significantly

then your are forcing the tile.

4. While cutting watch to be sure that the blade remains wet. If it runs dry

check the action of the pump and the water level of the tub.

5. If the motor stops suddenly flip the power switch to the off position.

Wait approximately 15 minutes remove the circuit breaker cap located

directly above the power switch and push the reset button.

Parallel Guides

If you have to cut a number of tile to the same dimension using the

Parallel guide may save you a significant amount of time.

1. Mark the first tile to the correct dimensions allowing space for grout.

2. With the motor turned off place the marked tile on the table against the

fence. Align the cut mark with the blade.

3. Loosen the locking knob on the parallel guide. Place the hooked

portion of the guide over the upturned edge of the table on the side of

the cutting groove where you have placed the part of the marked tile

that you intend to keep and use after cutting. The parallel guide will be

parallel to the tile and perpendicular to the fence.

4. Slide the parallel guide along the fence until it meets the tile making

sure that the mark on your tile remains in line with the blade.

5. Tighten the locking knob on the parallel guide.

6. When you are satisfied that the tile is aligned with the blade and the

guide is in place and it is safe to do so, turn on the power switch. Cut

the tile as described in previous instructions.

7. Once the cut is finished make sure the tile has been cut to the correct

dimensions before you cut any more tiles.