Owner`s manual

12
ADJUSTMENTS
DRILLING DEPTH
Your drill press has been equipped with a new type depth adjustment. To set the
depth stop, loosen the depth locking nuts and rotate them to the desired depth as
indicated on the scale.
SPINDLE RETURN SPRING
The spindle is equipped with an auto-return mechanism. The main components
of which are a spring and a notched chrome housing. The spring was properly
adjusted at the factory and should not be readjusted unless absolutely
necessary. If required, proceed as follows:
- Unplug the drill press.
- Loosen the two housing nuts (1) approximately 1/4".
- Firmly hold the spring housing (2) and pull it out so it clears the raised notch
(3).
- Turn it until the next notch is engaged with the boss. To increase
the tension, turn it clockwise and counter-clockwise to decrease
the tension.
- Tighten the two nuts.
- Do not over-tighten the nuts, as it will make the spindle handle sluggish.