Owner`s manual

CT056 6” WOODWORKING JOINTER

Operation, Continued

Knife Replacement

Disconnect the CT056 from its power source.

Loosen the five Hex-head knife-setting screws starting with the middle one and

then followed by the two end screws and then the remaining two.

Carefully remove the knife and the locking bar

being careful not to lose any of the knife

pressure springs.

Repeat this procedure on the second and third

knives.

To reassemble the knives into the cutter head,

reverse the above procedure, being certain to

place the springs in position and to be sure that sharp edges of the knives are

facing the infeed table.

Tighten the hex-head screws in reverse order being sure that all are secure.