Owner`s manual

CT056 6” WOODWORKING JOINTER
Operation, Continued
Cutter Head Removal
When necessary to remove the cutter head assembly for maintenance, the
following procedures should be followed.
Disconnect the CT056 from the power source.
Remove the fence.
Remove the drive belt.
Set both the infeed and outfeed tables to their lowermost positions, being sure to
loosen the butterfly lock screws first.
Remove the two bearing cap screws.
From the drive belt end, slide the cutter head assembly out.
To re-install, reverse the above procedure and when reassembled be sure to
adjust the feed tables.
14