User manual

10
Slide the hand wheel onto the hand wheel
shaft in front of the saw and secure it using
the lock knob provided. Thread the hand
wheel handle into the hole on the hand
wheel and tighten it. See figure-9.
Figure-9 Installing the blade height hand
wheel
Turn the hand wheel to lower the blade all
the way into the saw. Put the saw upside
down on the floor or on any surface that will
not damage the cast iron table. Place the
stand on the saw as shown in figure-9 with
the CX202 Model# facing the front of the
saw. Align the holes on the stand with the
holes on the bottom of the saw and secure
it using bolts, washers and nuts provided.
Figure-10 Securing the saw to the stand
Get the help of an assistant to turn the saw
upright. Adjust the feet to level the saw from
four sides.
Slide the blade tilt hand wheel on the shaft
located on the side of the saw as shown in
figure-11 and secure it using the lock knob.
Thread the hand wheel handle into the hole
on the hand wheel and tighten it properly.
Figure-11 Installing blade tilt hand wheel
Attach the extension wings to the two sides
of the table using nuts, bolts and washers
provided.
Figure-12 Installing the extension wings
Place a straight-edge on the main table and
the extension wing, and make sure they are
flat with each other.
If the mating surface of the extension wing
tilts down, remove the wings and use a
masking tape along the bottom edge of the
main table to shim the extension wing up.